V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
-
Hold the bumper up against the car and connect the connector for the sensors to the connector clamped to the car.
-
Reinstall the bumper by repeating the instructions in steps 2-5 in reverse order.
-
Install the two outer sensors in the sensor holders and connect them to the routed cable harness (see illustration 34).
-
Connect the routed cable to the available port on the parking assistance module (PAM).
-
It is secured with Velcro on the left-hand side in the cargo compartment behind the wheel arch.
Note! Make sure that the connector clicks into place and is properly secured.
-
Clamp the sensor cable so that it is not chafed or causes noise.
Finishing work
Reinstall:
-
the sills, front and rear
-
the side panels in the cargo compartment
-
the floor carpet.
-
Programme the software in accordance with the service information in VIDA.