V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
Install the heating element. Refer to: Heater pad backrest and cushion, replacing See: Body and Frame/Seats/Seat Heater/Service and Repair.
Note! Ensure that the wiring is routed through the holes exactly as illustrated.
Caution! Do not pinch the hose from the silicon pad to the pressure sensor during installation.
Caution! Do not pinch the hose from the silicon pad to the pressure sensor during installation.
Install:
-
the 2 screws. Tighten
-
the connector at the end mounting
-
the connectors on the multi-connector
-
the pressure sensor/silicon cushion on the bracket under the seat. Secure the silicon hose in the clip/holder
-
the pressure sensor/silicon cushion using 2 clips
-
the seat cushion. Fold down and secure the upholstery. See: Upholstery seat cushion, replacing See: Body and Frame/Seats/Seat Cover/Service and
Repair/Front Seat/Upholstery Seat Cushion, Replacing
-
the battery negative cable. See: Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.
Finishing
Storing the ID number for the occupant weight sensor (OWS)
