V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
Unhook the fuel line from its mountings in the sub-frame.
Removing the ball joint nuts (both sides)
Remove the nut for the lower ball joint and control arm. Clean the exposed threads outside the nut. Spray using rust solvent before removing the nut.
Counterhold with Torx TX 40 at the ball joint pinion when removing the nut. This is so that the ball joint boot does not turn.
Remove the nuts for the anti-roll bar links. Unhook the links from anti-roll bar.
Removing the bracket for the power supply cable for the heated oxygen sensor (HO2S)
Remove the screws for the bracket.
Applies only to right-hand drive cars
Remove the front cross member
Remove:
-
the screws for the cross member
-
the screws for the rubber mounting
-
the brake pipe from its holders
Removing the collision protection system over the steering gear
Applies only to right-hand drive cars
Remove the collision protection over the steering gear.
Removing the steering gear from the sub-frame