V70 2.5T L5-2.5L Turbo VIN 59 B5254T2 (2006)
Lubricate the edges of the new seal using automatic transmission fluid.
Install locating pin 999 5769.
Install the seal on the locating pin. Use drift 999 5770.
Tap in the seal until the drift is against the transmission.
Remove the locating pin.
Install the drive shaft.
Check the oil level.
Install the splashguard under the engine.
Right-hand side
Preparatory work
Remove the drive shaft.
Removing the differential seals, right-hand side
Place a container underneath the transmission.
Install the cap nut for extractor 999 5768.
Lightly grease the locating pin on the extractor.
Use a ratchet with an extension and socket.
Press the extractor in against the seal at the same time as the extractor is turned.
Tighten so that the threaded cone screws firmly into the seal.
