V70 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
the ignition coils without removing the connectors.
NOTE: Mark up before removal.
-
the two ground connections
-
the connector for the variable valve timing solenoid
-
the right front wheel
-
the plastic nuts holding the cover for the fender liner.
Set the engine to the test position
Install tool 999 5754 at the rear of the intake camshaft.
Turn the crankshaft in the direction of engine rotation (clockwise) until the marking on the tool (In1/Ex4) is in opposite the thin flange running straight
over the top of the entire cylinder head.
Remove all plugs from the test holes.
NOTE: If the crankshaft is turned to far, it is essential that it is turned back at least a quarter of a turn so that it can then be turned clockwise to the
correct position.
Check the valve clearance
