V70 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Remove the screw for the drive shaft mounting
-
Remove the screw from the upper outer mounting for the control arm
-
Press off the wheel spindle. Use tool 951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder and 999
7054 Adapter incl. 2x MC6C M6X12 See: Tools and Equipment/999 7054 Adapter Incl. 2X MC6C M6X12 , 999 7031 Locating pin See: Tools
and Equipment/999 7031 Locating Pin , 999 7030 Mounting bracket bushing replace See: Tools and Equipment/999 7030 Mounting Bracket
Bushing Replace together with threaded rod 999 7039 Connecting rod M16X360 See: Tools and Equipment/999 7039 Connecting Rod
M16X360.
Note! Only press until the bushing releases from the splined joint.
Press in the drive shaft and remove the spindle.
Removing the bushing
-
Install the hydraulic cylinder. Use tool 951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder with 999
7054 Adapter incl. 2x MC6C M6X12 See: Tools and Equipment/999 7054 Adapter Incl. 2X MC6C M6X12 , 999 7035 Sleeve See: Tools and
Equipment/999 7035 Sleeve , 999 7036 Drift See: Tools and Equipment/999 7036 Drift and 999 7039 Connecting rod M16X360 See: Tools and
Equipment/999 7039 Connecting Rod M16X360
-
Pull the bushing out.
Installation
Installing the bushing
Note! To ensure that there is no exhaust leakage, see: Flanged joint, assembling See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Pipe/Service and Repair/Flanged Joint, Assembling.