V70 2.5T AWD L5-2.5L Turbo VIN 59 B5254T2 (2003)
Install:
-
the wheel spindle to the upper control arm.
Note! Do not tighten so hard that the toothed segment goes into the bushing on the wheel spindle.
-
the lateral links on the sub-frame. Finger tighten.
-
the link for the inner mounting for the control arm. Finger tighten.
-
the lower control arm on the sub-frame. Finger tighten.
Press the control arm to the normal position using a mobile jack. See Normal position See: Service and Repair/Procedures.
Install an M12 x 70 mm screw together with a nut in the hole for the anti-roll bar on the control arm, to facilitate measuring.
Check the height measurement on the control arm. If necessary adjust the height measurement with a tie strap.
Tighten the wheel spindle to the upper control. Use an M10 screw.
Remove:
-
the lateral link from the wheel spindle
-
the lower control arm from the sub-frame.
