V70 AWD L5-2.4L Turbo VIN 56 B5254T (1998)
-
Tighten bolts to 105 Nm (77.5 ft. lbs.) plus 120 degrees. Use protractors 951 2050.
-
Now tighten support bracket bolts to 50 Nm (36.9 ft. lbs.).
-
Move jacking unit to RH side and repeat as above.
In cars with turbo
Install:
-
Turbo air pipe to hose connection by lower intercooler connection.
Finishing work with car jacked up
Install:
-
Bolt to negative lead clip on frame member.
-
Cable pipe to subframe.
-
Front protective cover.
Push front of cover home.Push it forward and push it up at the back so the cover guide fits into its track.
-
Bolts.
Installing gaiter, nut, bolt and locking lug
Install:
-
Gaiter on steering wheel shaft joint/bodywork opening.
Make sure that gaiter ends up in the correct position. Push gaiter circlip home and turn back top of gaiter.
-
Steering wheel shaft joint to steering wheel shaft. Use new locknut. Tighten to 20 Nm (14.8 ft. lbs.).