V70 AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Crankshaft Main Bearing Seal: Service and Repair
Special Tools:
-
Handle tool No. 999 1801, or equivalent
-
Gear Sector tool No. 999 5112, or equivalent
-
Driver tool No. 999 5430, or equivalent
NOTE: For additional information on special tools and equipment used in this procedure, refer to Service and Repair. See: Tools and Equipment/Tools
For Engine Service and Repair
Procedure
NOTE: Proceed with transmission removed as described under Transmission Removal, refer to Transmission and Drivetrain.
1. Remove flywheel/drive plate:
-
Use gear sector 999 5112, or equivalent.
2. Replace seal:
-
Remove seal using a groove-cut chisel.
NOTE: Do not damage contact surfaces. Note the position of seal in relation to sealing flange.
-
Oil seal contact lip.
-
Install seal using driver tool No. 999 5430 and handle tool No. 999 1801, or equivalents.
-
Knock in seal until the driver hits the crankshaft.
3. Reinstall flywheel/carrier plate:
-
Use gear sector tool No. 999 5112, and special screws tool No. 999 5593, or equivalents.
Manual Transmission:
-
Reinstall the flywheel using the three special screws and tighten (diagonally) to: 45 Nm (33 ft lb)