V70 AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Clean the splines on the drive shaft.
Turn in the stub axle and locate the drive shaft in the hub.
Install drive shaft screw and finger-tighten. Lubricate the screw.
Install
-
both screws retaining the spring strut in the stub axle. Use new screws and nuts. Tighten to 105 Nm and angle-tighten 90°. Use bevel protractor
951 2050
-
anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm
-
ABS sensor cable
-
ABS sensor onto stub axle. Tighten ABS sensor to 10 Nm
Note! Ensure that the sensor seat in the stub axle is absolutely clean. Clean the ABS sensor with a soft brush.
-
tie rod end onto the stub axle. Use a new nut. Tighten to 70 Nm.
-
brake disc. Tighten brake disc locating pin to 8 Nm.
Note! Ensure that the brake disk and wheel rim hub mating surfaces are clean.
Tighten drive shaft screw to 50 Nm. Use a screwdriver as counterhold on the brake disc.