V70 AWD L5-2.4L Turbo VIN 56 B5254T (1998)
6. Installing driveshafts.
NOTE: Take care not to damage driveshaft seals or boot (gaiter).
RH driveshaft:
-
Install bearing cap. Tighten to 25 Nm (18 ft. Lb.).
-
Install splashguard under engine. (Earlier models).
LH driveshaft:
Push driveshaft in properly so it locks into the circlip in the differential slot.
Make sure driveshaft circlip engages in slot.
Check by pushing in driveshaft inboard universal joint carefully.