V70 GL L5-2.4L VIN 55 B5254S (1998)
-
Master cylinder and EBD pressure sensor. Use new nuts. Tighten to 25 Nm (18.4 ft. lbs.).
Remove:
-
Plugs from brake pipe and connect brake pipe.
Tighten to 14 Nm (10.3 ft. lbs.).
Connect:
-
Connector to EBD sensor.
-
Brake fluid reservoir, as per (Not for VADIS use) Brake fluid reservoir, replacement and cleaning Brake fluid reservoir, replacement and cleaning.
Finishing
-
Bleed braking system as per (Not for VADIS use) Bleeding brakes with bleeding unit. Bleeding brakes.Then continue as per instructions below.
-
Bleed clutch on cars with manual transmission.
Clean off any brake fluid spillages with lukewarm water and car-wash shampoo.
Pressure-testing the braking system
Once the system has been bled, it must be pressure-tested.
Depress the brake pedal as if braking sharply, nearly enough to lock the wheels, for 30 seconds. Check if there is any brake fluid leaking from the
master cylinder.