V70 GL L5-2.4L VIN 55 B5254S (1998)
-
Positive and negative leads from battery.
-
Positive leads from battery shelf.
-
Sparkplug leads from coil.
-
Sparkplug leads from mountings on air filter casing.
-
Ground braids from back of valve cover.
-
Connectors from brake fluid reservoir cap, EBD pressure sensor, AC pressostat and anti-theft alarm horn.
-
Cable from mountings on air hydraulic brake power assist unit (brake servo).
-
Non-return valve and vacuum hose from air hydraulic brake power assist unit (brake power).
Remove:
-
Bolt from torque member/torque arm.
-
Air inlet hose from air filter casing.
In cars with automatic transmission
Disconnect upper oil radiator hose from radiator.
Use expanding circlip pliers on hose mounting.
In cars with turbo
Disconnect turbo air pipe from hose connection by upper intercooler connection.
Disconnect upper engine oil radiator hose from radiator. Use expanding circlip pliers on hose mounting.
Removing master cylinder
In cars with manual transmission
-
Drain brake fluid reservoir
Block hose to clutch cylinder with hose pliers.
Disconnect hose from brake fluid reservoir.
All cars
Disconnect brake pipes from mountings on firewall.
Remove:
-
Master cylinder from air hydraulic brake power assist unit (brake servo).
Lift master cylinder up carefully to avoid damaging brake pipes.
Keep master cylinder in position with a tie strip.
Note: Fix master cylinder in a horizontal position to prevent air entering braking system.
Removing sound insulation
Remove:
-
Sound insulation on driver's side.
In cars with SRS:
