V70 GL L5-2.4L VIN 55 B5254S (1998)
Use 999 5517 (bright) (2 x for LH side) and 999 5518 (yellow) (2 x for RH side).
Position jack998 5972 under LH side of frame.
Remove:
-
Front and rear frame bolts.
Install:
-
Tool 999 551 7, the front one with the bolt washer.
Tighten tools as far as they will go. Then tighten the tool nuts.
Remove:
-
Support bracket bolts by rear lever arm bolt.
Move jack to RH side and repeat as above.
Lowering subframe
Start by lowering front of frame to half the tool's bolt length.
Now do the same with the rear of the frame.
Now lower the frame to the full length of the tools using the same procedure.
In cars with turbo:
-
Check while lowering that the turbo air pipe by the lower intercooler connection does not get caught in the radiators.
Note: It is important to lower the frame in the correct order, otherwise the steering wheel shaft joint will catch in the body opening.
Removing air hydraulic brake power assist unit (brake servo)
