V70 GL L5-2.4L VIN 55 B5254S (1998)
7. Install pump wheel in housing and check for play:
-
Place large pump wheel in housing with markings upwards.
-
Install the small pump wheel.
-
Check for play. If there is too much play replace pump. Assemble pump
NOTE:
-
If the play between the outside surfaces and the oil pump housing are greater than 0.35 mm and oil pressure is below 1 bar (14 psi) at 100°C
(212°F), the oil pump should be replaced.
-
Measure play with a feeler gauge.
8. Install oil pump:
-
Use new gasket.
-
Use drift tool No. 999 5455, or equivalent when installing pump.
Use screws as guide.
-
Pull in the oil pump with the crankshaft center nut.
-
Tighten screws crosswise to 10 Nm (84 inch lbs.).
-
Install crankshaft belt pulley using center nut and a spacer.
9. Install timing belt:
-
Install belt tensioner screws, tighten to: 25 Nm (18 ft lb).
-
Place belt around the crankshaft and right idler pulley.
-
Place belt over camshaft pulley.
-
Place belt around water pump and press belt over the tensioner pulley.
10. Install vibration damper:
-
Pull locking pin out of belt tensioner.
-
Install vibration damper.
-
Tighten center nut to 180 Nm (133 ft lb).
-
Use counterhold 999 5433, or equivalent.
-
Remove counterhold (999 5433, or equivalent) and tighten screws to: 25 Nm (18 ft lb).
-
Install upper timing cover.