V70 GL L5-2.4L VIN 55 B5254S (1998)
-
Install the timing gear pulleys with two screws so that they precisely act on the pulleys.
-
Tighten center screw on the camshaft belt tensioner to 5 Nm (3.7 lb ft)
-
Install new camshaft belt over crankshaft pulley wheel.
Then install the belt in the following order:
1. Idler pulley.
2. Intake cam pulley.
3. Exhaust cam pulley.
4. Water pump.
5. Belt tensioner.
Note!
Adjust timing gear pulleys so that the screws are not at the limit positions in any of the oval holes.
Tighten timing belt
Adjust the belt tensioner:
Note!
This adjustment is always carried out on a cold engine. Suitable temperature is 20°C/68°F. At higher temperatures, for example with
engine at operating temperature or at higher ambient temperature, the needle is further to the right. The illustration shows the needle
position when adjusting the camshaft belt tensioner at different engine temperatures.
Tighten the timing belt as follows:
