V70 GL L5-2.4L VIN 55 B5254S (1998)
-
servo reservoir and expansion tank.
-
Lift up and place on top of engine.
Note! Take care not to spill servo oil from the bleed hole in the cap.
Place paper wipe around the reservoir and then cover with a plastic bag as protection.
Spilled servo oil is highly inflammable.
-
auxiliaries belt.
-
front camshaft belt cover.
Position engine according to marking
Raise the car.
-
Remove right front wheel.
-
Remove nut from fender liner cover.
-
Place upper camshaft belt cover.
-
Turn crankshaft clockwise until the markings on the crankshaft and camshaft pulley correspond.
-
Remove upper camshaft belt cover.
Removing timing belt
Slacken off belt tensioner
-
Slacken off belt tensioner center screw slightly.
-
Hold the center screw still and turn the tensioner eccentric clockwise with a 6 mm (0.24 in) allen key to "10 o'clock".
-
Remove the camshaft belt from the belt tensioner, camshaft pulley and idler pulley and the water pump.
