V70 GL L5-2.4L VIN 55 B5254S (1998)
Check the dust boot on the anti-roll bar link for damage.
Check the link threads for damage.
Lubricate the threads.
Reinstall the upper link of the anti-roll bar on the spring strut. Use a new locknut. Tighten to 50 Nm (36.9 ft. lbs.).
Install the tie rod on the stub axle. Use a new locknut.
Tighten to 70 Nm.
Check that the brake disc mating surfaces to the wheel bearing unit are smooth and even.
Install
-
the brake disc.
-
the brake disc locating pin. Tighten to 8 Nm (5.9 ft. lbs.).
Check the mating surfaces of the brake caliper and stub axle.
Clean and grease the surfaces of the steering limiter.
Install the brake caliper. Use new screws. Tighten to 100 Nm (73.8 ft. lbs.).
Tighten the center screw of the drive shaft to 50 Nm (36.9 ft. lbs.). Counterhold the brake disc with a screwdriver.
