V70 GL L5-2.4L VIN 55 B5254S (1998)
NOTE: Front knock sensor must be tightened in the 4 o'clock position and rear knock sensor in the half-past five position.
-
Knock sensor connector.
Installing Intake Manifold
Install:
-
New gasket with four lower intake manifold screws.
-
Intake manifold
NOTE: Check that there are no foreign bodies in the intake manifold before installing it.
-
Intake manifold.
NOTE: Ensure that crankcase ventilation hose is not trapped between cylinder head and intake manifold when tightening.
-
Three upper intake manifold screws. Tighten all screws to 20 Nm (15 ft.lbs).
-
Support bracket.
-
Dipstick.
Installing Fuel Rail
Install:
-
Fuel rail and fuel pipe clips (two).
-
New screws and tighten. Tightening torque 10 Nm.
-
Remove injector holders.
-
Injector connectors. Check that each connector is fitted with rubber seal.
-
Injector cable harness clip.
-
Fuel rail cover.
Reinstalling Hoses And Connectors
Install:
-
Idle air control valve and throttle position sensor connectors.
-
Brake system servo hose.
-
Fresh air hose.