V70 GL L5-2.4L VIN 55 B5254S (1998)
Clean the splines on the drive shaft.
Turn in the stub axle and locate the drive shaft in the hub.
Install drive shaft screw and finger-tighten. Lubricate the screw.
Install
-
both screws retaining the spring strut in the stub axle. Use new screws and nuts. Tighten to 105 Nm and angle-tighten 90°. Use bevel protractor
951 2050
-
anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm
-
ABS sensor cable
-
ABS sensor onto stub axle. Tighten ABS sensor to 10 Nm
Note! Ensure that the sensor seat in the stub axle is absolutely clean. Clean the ABS sensor with a soft brush.
-
tie rod end onto the stub axle. Use a new nut. Tighten to 70 Nm.
-
brake disc. Tighten brake disc locating pin to 8 Nm.
Note! Ensure that the brake disk and wheel rim hub mating surfaces are clean.
Tighten drive shaft screw to 50 Nm. Use a screwdriver as counterhold on the brake disc.