V70 GL L5-2.4L VIN 55 B5254S (1998)
-
Remove the power steering pump three mounting screws through the pulley holes.
-
Remove oil hose holder and connector. Push holder to one side.
-
Remove the pressure hose from the power steering pump.
-
Remove the O-ring.
-
Collect any oil.
-
Remove power steering pump by lifting straight up.
-
Raise front suspension so that wheels hang free.
-
Turn the steering wheel between full locks. Collect fluid spillage from pressure and return hoses.
Installing power steering pump
Installing power steering pump
Note! Place paper over the Generator (GEN) as protection against oil.
Install
-
servo pump
-
the three mounting screws through the pulley. Tighten to 25 Nm (18.44 ft. lbs.).
-
oil hose holder and connector
-
return and pressure pipe. Use a new O-ring on the pressure pipe
-
drive belt
-
cold air inlet hose to the control module.
Finishing
Top up oil level in the servo reservoir and bleed the system