V70 GL L5-2.4L VIN 55 B5254S (1998)
6. Installation of new seal
-
Apply a small amount of grease to sealing lip.
-
Use drift tool No. 999 5541 and handle tool No. 999 1801, or equivalents.
NOTE: Do not use the old type of drift (tool No. 999 5478).
-
Left side:
Place the side of the drift marked AW against the seal ring.
-
Right side:
Place the side of the drift marked AW against the seal ring turned as shown in the illustration.
-
Carefully tap in the seal ring until the drift is up against the transmission housing.
7. Installation of right drive shaft
NOTE: Make sure that the seal rings in the transmission and the boot on the drive shaft are not damaged.
-
Replace bearing cap.
Tighten to: 25 Nm