V70 GL L5-2.4L VIN 55 B5254S (1998)
8. Installation of left drive shaft
-
Ensure that the Anti-Lock Braking System ABS sensor pulse wheel is free from dirt.
-
Press the drive shaft in firmly so that it locks on to the differential gear.
Ensure that the drive shaft lock ring sits in its locking groove
Check by pulling carefully on the drive shaft CV housing.
NOTE: Make sure that the seal rings in the transmission and the boot on the drive shaft are not damaged.
9. Reinstall:
-
Link/ball joint to stub axle.
Remove sleeve tool No. 999 5562, or equivalent, from the ball joint.
Use new nuts on the screws.
Tighten to: 40 Nm.
-
Link to anti-roll bar.
Use a new nut.
Tighten to: 50 Nm
-
Brake hose bracket.
10. Reinstallation of wheels
-
Reinstall the wheels on both sides:
Lubricate the hub center location dowel for the rim with rust inhibitor part No. 1161030-0, or equivalent.
Tighten the studs lightly.
Then tighten diagonally to: 110 Nm.
11. Check transmission oil level.
