V70 GL L5-2.4L VIN 55 B5254S (1998)
13. Install:
-
New boot (gaiter) on driveshaft.
-
Spider, lining up as above.
NOTE: Spider's position relative to shaft (non-turbo models only).
Tap spider down until it reaches the stop.
-
Use Drift tool No. 999 5519, or equivalent.
Install circlip, making sure it engages in its groove.
Assembling inboard and outboard driveshafts
14. Non-turbo models:
Pack grease into joints.
Use grease pack part No. 1161430-2 (190 g), or equivalent.
15. Turbo models:
Install needle bearings on spider.
-
Grease spider pins, use grease pack part No. 1161430-2 (190g), or equivalent.
-
Pack grease into joint, use grease pack part No. 1161430-2 (190g), or equivalent.