V70 GL L5-2.4L VIN 55 B5254S (1998)
Shifter M/T: Service and Repair
Shift Lever
Special Tools
-
Drift tool No. 999 2412, or equivalent
-
underlay ring No. 999 2852, or equivalent
-
Refer to special tool section for additional tool information. See: Tools and Equipment
Preparation
-
Remove shift refer to steps 4, 6 and 7 of Selector Cable, M/T replacement. See: Shift Linkage/Shift Cable/Service and Repair
Procedure
1. Remove:
-
Link plate clip
-
Link plate and bushings
-
Ball and socket joint from shift lever link plate.
(If only replacing bushings or link plate, see step 5).
2. Replacing shift lever and shift lever ball and socket joint:
Fix shift lever casing in a vice.
Remove shift lever knob and boot (gaiter) from lever (steps 1 and 2 of Shift Knob and Boot Replacement). See: Shift Knob and Boot (Gaiter)
To remove shift lever ball and socket joint from shift lever casing, ease up socket locking tabs.
Lift ball and socket joint and shift lever from shift lever casing.
-
Replace ball and socket joint and/or shin lever as necessary.
3. Fitting socket to shift lever