V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Crankshaft: Service and Repair
Crank, Pistons and Rods, Reassembly
Special Tools:
-
Standard Handle tool No. 999 1801, or equivalent
-
Installation tool No. 999 5430, or equivalent
-
Base tool No. 999 5971, or equivalent
-
Magnetic Stand tool No. 999 9696, or equivalent
Universal Tools:
-
Piston Ring Compressor tool No. 115 8281, or equivalent
-
Roller tool No. 951 1205, or equivalent
-
Piston ring compressor tool No. 998 5424, or equivalent
NOTE: For additional information on special tools and equipment used in this procedure, refer to "Tools For Engine Reconditioning". See: Tools and
Equipment
Procedure
1. Classification of crankshaft main bearings:
-
Clean main bearing seats.
-
Check that components are clean and free of damage.
-
Check classification markings on cylinder block and crankshaft.
NOTE:
-
Each bearing seat is marked with the cylinder no. and a classification letter for the block and crankshaft.
-
Use the table below to select the right bearing shells.
2. Selecting bearing shells:
-
Install main bearings in cylinder block (See table).
-
Oil bearing shells liberally on crankshaft side.
-
Install flanged shells in rear most position.
-
Example: Classifying no. 1 bearing.
Marking on block is B.
Marking on crankshaft is C.
Accordingly, use a red shell in the block and a yellow shell in the intermediate section.