V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
-
Screw and washer for stay.
-
Nut for lower control arm mounting.
Install:
-
Bracket.
-
Screw for stay. Use locking fluid on screw.
Note! The washer should not be installed again.
Tighten to 80 Nm (59 ft.lbs).
-
Nut for lower control arm mounting. Use a new nut.
Tighten to 80 Nm (59 ft.lbs).
-
Wheels.
Tightening wheel studs
When installing and tightening wheel studs the following applies.
Ensure that the brake disk and wheel rim mating
surfaces are clean. Grease the hub center location
dowel for the rim. Use rustproofing agent 1161030-0.
Tighten screws loosely. Then tighten crosswise to 110 Nm (81 ft.lbs).
When tightening with impact wrench, use torque socket 1158147-7.
It is important to tighten crosswise to prevent tension being produced in the brake disc.
Note!
The torque socket wrench is designed for tightening wheel studs using standard, air-driven impact tighteners providing a torque of 250-350 Nm
(184-258 ft.lbs).
WARRANTY STATEMENT: Claims may be submitted under the New Car Limited Warranty when a manufacturing defect is present using claim type:
01
Operation No.
Labor description
Time allowance
