V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Drill a 5 mm hole in the plate between the clamp for the backrest mounting and the clip for the wire for the seat belt tensioner.
Position the hole approximately 15 mm (0.6 ) from the clip.
Remove any burs.
Install the:
-
ground lead using screw p/n 958244. Route the ground lead along the existing wire through the backrest upholstery
-
cable for the seat belt tensioner in the clip.
16
Installing the backrest cushion
Push the padding and upholstery back into position. Pull the tie strap closed at the inner edge of the backrest upholstery.
Install the:
-
guide for the inner mounting for the cushion
-
inner half moon clip and ring for the strap for the seat belt
-
remaining half moon clips
-
backrest (1). Tighten to 48 Nm (35 lbf.ft).
Connect the seat belt tensioner connector.
Install the strap for the seat belt buckle.
