V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
18. Solenoid SL
-
Solenoid SL is in two variants:
Early types with the connection to the cable harness from the right
Later types with the connection from the left.
-
Early version and replacement parts
Illustration (C).
-
Late versions
Illustration (D).
-
Solenoid SL is only available in the early version as a replacement part
Illustration (C).
19. Checking resistance
-
Solenoids S1, S2, SL:
Measure resistance between pin in solenoid connector and transmission ground terminal.
The correct resistance should be: 10-15 ohms
-
Solenoid STH:
Measure resistance between pins in solenoid connector.
The correct resistance should be: 2-6 ohms
20. If solenoid resistances are correct:
-
Perform preparations as per step 2 of Solenoid Wire Harness Inspection/Replacement. See: Valve Body/Service and Repair
-
Check wiring harness between solenoids and-connector on transmission as per step 3 of Solenoid Wire Harness Inspection/Replacement. See:
Valve Body/Service and Repair.
-
If solenoid S1, S2 or SL value is incorrect:
Replace solenoid as outlined in the following steps.
-
If solenoid STH value is incorrect:
Replace complete control system as per step 2 of Control System Replacement. See: Valve Body/Service and Repair
(Solenoid STH is calibrated together with the control system).
