V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
Applies to cars from model year 2005- (CH 425000-)
-
Take the cable (1) for power supply from the kit. Connect the ground lead to the existing ground terminal behind the battery. Tighten the screw.
Tighten to 10 Nm (7 lbf.ft.). Position the red/white (R/W) single cables (2) by the rear fuse holder
-
Route the cable harness on the left-hand side of the cable duct. The cable with the blue connector (3) must be routed to the pre-routed connector
for the DIN cable.
Connection to the fuse holder
Applies to cars up to and including model year -2004 (CH -424999)
-
Remove the rear electronic module (REM). First open the catch (1) on the top of the module. Fold the module forward. Lift the module from the
mountings (2).
-
Position the red/white (R/W) single cable with the smaller cable terminal facing backwards along the cable. Insulate the cable. Secure the cable
using the foam tape from the kit. It must not come into contact with the chassis.
