V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
-
Take the bolt, nut and washer form the kit.
-
Place the bracket with the connector over the drilled hole.
-
If the bracket does not fit: Mark an area on the bumper cover where the corner (1) should be cut away and remove the section. If the car is
equipped with a protective plate on the rear bumper, it may require chamfering.
-
Secure the bracket to the towbar member.
-
Secure the cable at the towbar member with a tie strap from the kit.
-
Remove the two floor hatches in the cargo compartment.
