V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
-
Tighten the screws (2) and nut (3) to 136 Nm (100 lbf.ft.).
-
Wait for at least five minutes so that the joint has time to set. Then tighten the screws (8) on both sides, a quarter turn (angle tightening 90°).
Note! Torque tightened screws that have been removed must not be reused.
-
Underseal.
Applies to Sweden only
-
Underseal after the state roadworthiness inspection.
Only applies if the car is equipped with mouldings
-
Reinstall the mouldings (3) on the expander clips. Press the mouldings into place.
Applies to all models
-
If the guide lugs (3) and clips (4) have loosened - reinstall them.
-
Applies to cars with parking assistance: Lift up the bumper in position. Pull the cable for the sensors through the hole for the bumper's guide,
and pull the cable in from the inside.
-
Reinstall the bumper by pressing it forwards. Ensure that the four screws, protruding from the bumper, align with the holes in the car.
-
Before the bumper is completely installed, slide the top edge (1) into the grooves. Then slide the bumper fully in.
-
Check that the guide lug (4) and clip (5) are centred with the hole in the wheel arch lining.
