V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
-
Push out the cable to the engine compartment.
-
Detach the rubber grommet from the cable.
-
Cut off the larger top of the rubber grommet.
-
Install the cable in the grommet.
-
Reinsert the cable into the passenger compartment.
-
Connect the cable to the passenger compartment connector socket and press the sleeve over the splice.
-
Press the rubber grommet into place.
Applies to cars without a passenger compartment connector socket
-
Cut off the pre-punched engine insulation.
-
Remove the rubber grommet that is in front of the insulation.
-
Insert the new cable in the lead-in hole to the passenger compartment and press the rubber grommet, positioned on the cable, into the hole.
Steps 13-37 apply to the XC90
-
Detach the left-hand headlamp by pulling up the two locking pins and then carefully pulling away the headlamp forwards.
-
Carefully prize up the catch on the connector for the headlamp using a screwdriver.
-
Pull the catch up completely, detach the connector and place the headlamp to one side.
