V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
When replacing/machining the cylinder head
Lift out the valve lifters. Use a magnet or suction cup.
Remove the thermostat housing and transfer it to the new cylinder head.
Note! Pay attention so that the contact faces are not damaged.
Installation
Note! For tightening torques, see: Tightening torque See: Specifications/Tightening Torque.
Note! To ensure that there is no exhaust leakage, see: Flanged joint, assembling See: Exhaust System/Exhaust Pipe/Service and Repair.
Cleaning
Warning! Use a fume hood or extractor when using gasket solvent!
Clean the gasket faces for:
-
the manifold. Check that the studs are tightened
-
the coolant bypass channel
-
the thermostat housing
-
the intake manifold
-
the cylinder block
-
camshaft cover.
Blow the oil ducts clean.
Note! Use a razor blade or a gasket scraper and gasket solvent P/N 1161 440.
Setting up the engine
Position the crankshaft
Remove:
-
the mounting screws for the starter motor and pull loose the starter motor and place it to one side.
-
the blind cover plug.
