V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
Check that the mating surfaces on the propeller shaft CV joint and flange are clean.
Align the propeller shaft CV joint against the flange.
Install the screws loosely in the support for the centre bearing and the propeller shaft.
Install the propeller shaft using the marking made earlier.
Tightening the propeller shaft CV joint
Use new screws.
First tighten the screws crosswise. Tighten to 8 Nm. Then tighten to 30 Nm.
Use counterhold 999 7057 Counterhold See: Tools and Equipment/999 7057 Counterhold.
Tighten the screws for the support for the center bearing. Tighten to 25 Nm.
Tighten the screws for the propeller shaft center bearing. Tighten to 25 Nm.
Installing the three-way catalytic converter (TWC)
Install the three-way catalytic converter (TWC). See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair
Checking the oil level in the bevel gear
Check the oil level in the bevel gear.
Use correct oil. See applicable specifications.
