V70R L5-2.5L Turbo VIN 52 B5254T4 (2007)
Seals and Gaskets: Service and Repair
Sealing Rings Bevel Gear, Replacing
Sealing rings bevel gear, replacing
Special tools:
999 5371 NUTS-DIFF.BEARING) 1035 See: Tools and Equipment/999 5371 Nuts-Diff.Bearing) 1035
999 5654 Punch See: Tools and Equipment/999 5654 Punch
999 5655 Punch See: Tools and Equipment/999 5655 Punch
Note! To remove the drive shaft, see Bevel gear, B5254T2, AW50/51 AWD See: Service and Repair/Removal and Replacement/Automatic
Transmission Components/Bevel Gear, Replacing Bevel gear See: Service and Repair/Removal and Replacement/Automatic Transmission
Components/Bevel Gear, Replacing Bevel gear, B5254T2, M58 See: Service and Repair/Removal and Replacement/Automatic Transmission
Components/Bevel Gear, Replacing.
Sealing ring for drive shaft front right side, replacing
Removing the sealing ring
Lever the sealing ring off the crown wheel shaft.
Use a screwdriver or a jimmy bar.
Installing a new sealing ring
Install the new sealing ring for the drive shaft.
Lubricate the seal using wheel bearing grease, P/N 1161241-3.
Use drift 999 5654 Punch See: Tools and Equipment/999 5654 Punch. Tap in the ring to stop.
If also replacing the seal for the crown wheel shaft, proceed to replacing.
Note! To install the drive shaft, see Bevel gear, B5254T2, M58 See: Service and Repair/Removal and Replacement/Automatic Transmission
Components/Bevel Gear, Replacing Bevel gear, B5254T2, AW50/51 AWD See: Service and Repair/Removal and Replacement/Automatic
Transmission Components/Bevel Gear, Replacing Bevel gear See: Service and Repair/Removal and Replacement/Automatic Transmission
Components/Bevel Gear, Replacing.
Sealing ring for crown wheel shaft for bevel gear, replacing