V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
-
Push piston back in cylinder on brake caliper.
-
Check that dirt guard is positioned correctly.
-
Install new brake pads and install brake caliper.
-
Tighten locating pins to 30 Nm (22 ft.lb) and install protective caps.
-
Install retaining spring (3).
Finishing and checking
-
If brake hose was not unscrewed, go to Checking brake fluid level.
-
If brake hose was unscrewed, tighten brake hose onto brake caliper to 18 Nm (13 ft.lb)
Note! Make sure that hose is not twisted. There is a white line running along the hose which shows if the hose is twisted. Correct at other end of hose if
necessary.
-
Top up and bleed braking system as per Bleeding brakes. Then continue as below.
-
Check that there are no leaks and that brakes are working properly.
Checking brake fluid level
-
Push brake pedal down a few times.
-
Check level in brake fluid reservoir. Top up brake fluid if necessary.
Installation of wheel
-
Make sure that brake discs and rin contact surfaces are clean.
-
Grease hub center rim guide with anti-rust agent 116 1038-3.
-
Install wheel
