V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
protection. Spilled servo oil is highly inflammable.
-
3 nuts for the cable duct at the right suspension turret. Lift the duct away from the screws.
-
the auxiliaries belt.
-
the front camshaft belt cover.
Position the engine according to the marking
Raise the car.
Remove
-
the right front wheel.
-
the nuts for the cover in the fender liner.
Install the upper camshaft belt cover.
Turn the crankshaft clockwise until the markings on the crankshaft and camshaft pulley correspond.
Turn the crankshaft a further 1/4 of a turn clockwise, then back counter-clockwise until the markings correspond.
The markings are illustrated.
Remove the upper camshaft belt cover.
Removing the camshaft belt
Slacken off the belt tensioner.
Slacken off the belt tensioner center screw slightly.
Hold the center screw still and turn the tensioner eccentric clockwise with a 6 mm (15/64") Allen key to "10 o'clock".
Remove the camshaft belt from the belt tensioner, camshaft pulley and idler pulley.
Removing the timing gear pulley with the variable Valve Timing (VVT) unit
Use camshaft adjustment tool: