V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
3. Undo:
-
dipstick bracket
-
intake manifold screw in lower bracket
-
lower intake manifold screws a few turns.
4. Remove:
-
remove upper intake manifold screws.
-
intake manifold by lifting it approx. 20 mm. (Allow the crankcase ventilation hose run through the intake manifold without disconnecting it
from the flame trap, does not apply to turbocharger (TC) models).
NOTE: Check that there are no foreign bodies in the intake manifold before installing it.
5. Install:
-
new gasket which is held in place by the lower intake manifold screws. (Do not forget the clamp on the fourth screw on turbo models.)
-
intake manifold. (Do not forget the crankcase ventilation hose which comes up through the gap between the second and third ducts on
S-engines.)
-
three upper screws and tighten all screws from center outwards to 20 Nm (14.8 ft lb).
Part 1 Of 2