V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Cylinder Head Gasket: Service and Repair
Special Tools:
-
Angle Gauge tool No. 951 2050, or equivalent
-
Counterhold tool No. 999 5199, or equivalent
-
Drift tool No. 999 5449, or equivalent
-
Drift tool No. 999 5450, or equivalent
-
Locking tool No. 999 5451, or equivalent
-
Locking tool No. 999 5452, or equivalent
-
Holder tool No. 999 5453, or equivalent
-
Press tool No. 999 5454, or equivalent
-
Holder tool No. 999 5533, or equivalent
NOTE: For additional information on special tools and equipment used in this procedure, refer to Tools For Engine Service and Repair. See: Tools and
Equipment
Procedure:
1. Drain coolant and undo front exhaust pipe:
-
Remove battery negative lead.
-
Remove expansion tank cap.
-
Remove splash-guard under engine.
-
Open engine and radiator nipples, use hose to collect coolant.
-
Close nipples.
-
Remove exhaust manifold/front pipe nuts.
2. Remove exhaust manifold and fuel distribution manifold:
-
Remove:
Exhaust Manifold, as outlined in steps 1 and 2 of Exhaust System Inspection/Replacement. See: Exhaust System/Service and Repair
Timing Belt, as outlined in steps 1 through 6 of Replacement. See: Timing Components/Timing Belt/Service and Repair
-
Lift fuel distribution manifold and injectors and put to one side.
Use holder tool No. 999 5533, or equivalent, for the injectors.
-
Remove the two ground strips from engine.
NOTE: Ensure that injectors and needles are not damaged.