V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Evaporative Emission Control Canister: Service and Repair
Removing EVAP canister
Remove:
-
connector/outlet, press in catch and pull
-
connector/inlet, press in catch and pull
-
outlet hose from EVAP canister bracket.
Removing EVAP canister shut-off valve air hose clamp:
-
squeeze clamp with a pipe wrench. Hold in place
-
pry apart with a small screwdriver.
-
air hose from EVAP canister shut-off valve
-
rubber mounting with EVAP canister shut-off valve from EVAP canister bracket
-
two front and rear screws.
Remove:
-
nut on bracket at fuel filter.
Remove:
-
EVAP canister with bracket
-
Slacken off screw in underside of bracket (Torx 25).
-
EVAP canister from bracket.
Installing EVAP canister
-
In reverse order of removal.
Tighten screws to 25 Nm (18.5 ft.lb) and nut to 20 Nm (14.8 ft.lb).
Ensure that the EVAP canister:
-
engages in the catch at the front
-
engages in its groove the bracket.
Note! Use a new screw clip. Check that outlet/inlet connector catches engage.