V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Install protective socket 999 5562 on ball joint.
3. Install depressor on control arm
-
Install depressor 999 5563 on control arm.
-
Remove left engine mounting from transmission and sub-frame.
4. Detach drive shaft from transmission
-
Use jimmy bar 999 5462 between transmission and inside of drive shaft.
-
Fold out spring strut and remove drive shaft from transmission.
Let end of the drive shaft rest against subframe.
NOTE: Protect end of the drive shaft against dirt and mechanical damage.
5. Remove the seal ring
-
Use a jimmy bar.
6. Install a new seal ring
-
Smear some grease P/N 1161241-3, on the sealing ring lip.
-
Use drift 999 5541 and bar 999 1801.
Place the side of the drift marked AW against the drive shaft seal.
-
Tap in the seal ring until the drift is in contact with the transmission housing.