V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Installing Viscous Coupling
-
Check that the flange and viscous coupling mating surfaces are absolutely clean.
-
Align viscous coupling as marked.
-
Use new screws. Tighten crosswise in stages until the viscous coupling flange is in full contact. Tighten crosswise to 50 Nm (37 ft.lb.).
-
If reinstalling the old viscous coupling, continue with installing torque tube.
NOTE; If installing a new viscous coupling, measure according to Measuring flange, viscous coupling and Balancing procedure,See:
Drive/Propeller Shafts, Bearings and Joints After measuring continue installing flange to viscous coupling.