V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
6. LH driveshaft:
-
Remove driveshaft from transmission.
Use prying tool No. 999 5462, or equivalent, to apply leverage between transmission and inside of driveshaft.
NOTE: Take care not to damage driveshaft seal or boot (gaiter).
Installation
Special Tools
-
Counterhold Tool No. 999 5461, or equivalent
-
Counterhold Tool No. 999 5540, or equivalent
-
Torque Sleeve Tool No. 115 8147-7, or equivalent
Universal Tool
-
Protractor tool No. 951 2050, or equivalent
NOTE: The Procedure is the same for both LH and RH driveshafts unless stated otherwise.
Preparation
-
Check that ABS sensor and sensor wheel are free of dirt.
Procedure
1. Install driveshaft to transmission.
NOTE: Take care not to damage driveshaft seal or boots (gaiter).
RH Driveshaft:
-
Install bearing cap.
Tighten to: 25 Nm.
-
Install splashguard under engine (earlier models only).