V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Constant Velocity Joint Boot: Service and Repair
Special Tools
-
Pliers tool no. 981 4215, or equivalent
-
Refer to special tool section for additional tool information.
Preparation
-
Removing/installing driveshafts, see sections:
Axle Shaft Assembly, Constant Velocity Type, Removal steps 1 through 6. See: Axle Shaft/Service and Repair/Front/Removal
Axle Shaft Assembly, Constant Velocity Type, Installation steps 1 through 4. See: Axle Shaft/Service and Repair/Front/Installation
-
The Procedure is the same for both LH and RH driveshafts.
NOTE:
-
To make removal of driveshaft joints easier, insert a drift as shown.
-
The rounding off on the underside (R) prevents the drift from hooking into the driveshaft circlip slot.
-
The somewhat acute angle (ca 60°) gives the drift more contact with the inner race.
Procedures
1. Exposing outboard CV joint
-
Remove clips from boot (gaiter).
-
Remove boot from CV joint.
-
Clean CV joint free of grease.
-
Put driveshaft in a vice with the gap in the circlip at the top.
2. Remove CV joint from shaft
