V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Seals and Gaskets: Service and Repair
Input Shaft Seal
Special Tools
-
Extractor tool No. 999 5489, or equivalent
-
Drift tool No. 999 5490, or equivalent
-
Refer to special tool section for additional tool information. See: Tools and Equipment
Preparations
-
Before replacing gearbox input shaft seal, follow:
Steps 1 through 26 of transmission removal. See: Service and Repair
Step 2 of clutch replacement. See: Clutch/Service and Repair
1. Remove throwout (release) bearing sleeve.
-
Remove the three screws holding the sleeve.
2. Tap in extractor tool No. 999 5489, or equivalent.
NOTE: Jackscrew in extractor must be unscrewed.
-
Check that extractor grips input shaft seal. Remove Input shaft seal.
3. Install new input shaft seal.
-
Grease input shaft seal lip.
-
Use drift tool No. 999 5490, or equivalent
-
Tap seal in until drift touches transmission cover.
4. Install throwout (release) bearing sleeve.
-
Apply a little locking fluid to the bolts.