V90 L6-2.9L VIN 96 B6304S (1998)
-
Remove the support arm.
5. Remove the following:
-
Track rod screw and tap off rod from wheel bearing housing.
-
Nut to link screw in the wheel bearing housing.
Tap out the screw.
Use a brass drift.
-
Release compression tool and remove.
-
Repeat steps 3 and 4 on other side.
6. Loosen screws on lower rear axle beam.
-
Slacken screws approx. one turn.
-
Remove the two front screws and the spacers.
Tool No. 999 5579, Holder For Differential Housing, Rear Axle Beam Or Leaf Spring Bushing Replacement
-
Install retainer to front edge and rear edge of differential.
7. Position lift unit lightly against the lower rear axle beam.
-
Use universal fixture.
-
Remove the screws loosened earlier. Lower rear axle beam.