V90 L6-2.9L VIN 96 B6304S (1998)
4. Install the following:
-
The support arm with new screws and new nut in front and rear edge.
Do not tighten.
-
Tighten in the following order:
The rear screw, tighten to 80 Nm (63 ft. lbs.).
The nut in front edge, tighten to 80 Nm (63 ft. lbs.).
Screws in front edge, tighten to 50 Nm (37 ft. lbs.).
5. Install dampers (shock absorbers):
-
Standard type:
Compress damper by hand and install on support arm.
Use a new screw.
Tighten to 80 Nm (63 ft. lbs.).
-
Self-levelling type:
Release compression tool slightly so the damper can be attached to the support arm.
Push up to normal position.
Use a new screw.
Tighten to 80 Nm (63 ft. lbs.).
6. Release compression tool and remove.
-
Repeat operations on other side.
7. Install anti-roll bar.
-
Check that the washers and rubber bushings are in position on the anti-roll bar links.
-
Install anti-roll bar to rear axle beam.
Use new nuts.
Tighten to 30 Nm (24 ft. lbs.).
-
Install anti-roll bar to support arm.
Use new screws.
Do not tighten screws yet.
8. Install the wheels.
