V90 L6-2.9L VIN 96 B6304S (1998)
Install:
-
the distribution housing, starting with the 3 top screws. Make sure the housing is properly seated in the right mounting, insert the screw and tighten
-
tighten the 4 screws on the underside and the 3 screws on the left side. Tighten
-
the vacuum hoses as follows:
red mark:
upper vent, top
blue mark:
defroster vent, all the way back
yellow mark:
lower floor vent, all the way down
transparent/beige mark: Bi-level vent in the center
-
any connector for the temperature sensor in the distribution housing.
Installing the air distributor for the floor and its vents