V90 L6-2.9L VIN 96 B6304S (1998)
Radiator Cooling Fan Motor: Service and Repair
1. Remove battery
-
Disconnect battery positive and ground leads. Remove battery holder.
2. Remove fan unit
-
Remove upper mounting bolts (two).
3. Disconnect fan lead
-
Undo lead holder on crossmember.
-
Undo relay connector and disconnect ground lead from terminal on right-hand wheel housing in engine compartment.
4. Install new fan unit
-
Connect lead to connector and secure with cable tie.
-
Insert and tighten upper mounting bolts.
-
Reinstall battery and reconnect leads.
NOTE:
-
The fan ground lead is secured by at least two cable ties between relay and ground terminal and that connector is very firmly attached to
ground terminal on right-hand wheel housing in engine compartment.
-
Also take care to minimize flashover between lead and terminal.